12
3.2 Trip computer
When you swipe to the right out of the map screen you will reach the trip
computer application, which shows you lots of measured values. It has a
second page which you can call up by swiping up or down.
You can configure the values in the trip computer yourself by tapping on a
field and then choosing in the list which value should be displayed in this
field.
Tip: You can obtain the average figures, such as average speed, by
recording an activity.
3.3 Manoeuvre screen
To the left of the map view is the manoeuvre screen with the altitude
profile. It shows you the next manoeuvre in the middle. As on the map,
here too there are configurable displays showing route information or
activities at the top edge.
If you swipe further to the left on the manoeuvre screen, you get back to
the trip computer (and vice versa).
The button allows you to view the altitude profile in detail.
4. Main menu
You can compile the main menu according to your own preferences by activating the functions you want under
Settings > System / General > Main Menu Functions.
The main menu gives you access to the selected functions which are explained one after the other in the
following chapters. To switch from the map view to the main menu, tap on . To then return to the map view,
tap on the button in the lower left corner of the screen.
5. Extras
Functions which you have disabled under Settings > System / General > Main Menu Functions are
listed under Extras on the menu. These functions are also explained in the following chapters.
To Next Page
Loading...
