28
Please remove the protective strip from your
robot vacuum cleaner and the protective lm
from your docking | charging station.
1. Position your docking | charging station correctly against the wall and
on a at surface. Do not place any items within a range of 0.5m left + 0.5m
right and 1.5m frontal.
2. Connect the docking | charging station to the power supply.
3. Install the side brushes (L) is left and (R) is right.
4. Charging: put the robot vacuum cleaner correctly on the docking station
for charging (during charging, the indicator light on the robot ashes.
When the robot is fully charged, the light on the robot remains on. The
charging time is about 5 hours.
During the cleaning process, the robot can sense that its power is running
low. It will than automatically enter “Back to Charge” mode or you can also
command the Robot to enter “Back to Charge” mode through the “Back to
Charge” button
on the remote control.
Charging attention:
1. The docking | charging station cannot be used in environments with a
strong reection such as direct sunlight and nearby mirrors. If there are any
objects with strong reection, please cover these 7cm from the bottom. As
it can confuse the signal.
2. In order to ensure the normal working hours of the Robot, please fully
charge it before use.
3. When charging, do not attach the water tank to ensure the safety of
charging and to prevent possible damage to the oorings
5. PREPARATIONS BEFORE USAGE
To Next Page
Loading...
