General Operations
Turning the power On/Off
Press the a to turn the unit On or Off.
Volume Level Control and Memory
Rotate the VOL dial to adjust the volume.
It is also possible to set turn-on volume level by following the
procedure explained below.
1
. Rotate the VOL dial until it is set at the required volume.
2. Press the B for two or more seconds. The power will
be switched off and the current volume level recorded.
Muting the sound
press (MVTEISENS).
The R-ch/L-ch Level Meter flashes.
To restore the previous volume level, press (MUTE again.
Setting the Clock
The clock uses a 12-hour display system.
1.
Turn the ignition key to the ON position.
2. Press the a to turn on the unit.
3. Press and hold the B for more than two seconds to
enter the Clock setting mode.
4. Use thefollowing buttonsanddial tosettheclock. (The blink-
ing section can be adjusted.)
(livDI0)
: To activated Hour blink
(m) : To activated Minute blink
: Adjust the Hour and minute
5. Press the (,,,,,, momentarily to complete the Clock set-
ting mode.
Ignition-off Clock Recall
The display will illuminate showing the time and then auto-
matically shut off after 5 seconds.
Press the m while the ignition switch is in the “ OFF ”
position.
Display Priority Selector
Each time the m is pressed, the display window will
change as shown below ;
l
Radio mode
Frequency and Clock.
l
CD I CDC(CD changer) mode
Elaosed time and Clock.
E-3
To Next Page
Loading...
Need help?
General
