Radio Reception
Seek Tuning
Scan Tuning
1 . Press them to select the desired AM or FM band.
Press the <s*ND) to select the desired AM or FM band.
FMI+FMII+FMIII+AMI+AMII
(FM
III
& AM
II
are Travel Store bands.)
:: Hold the a pressed for less than 2 seconds.
The unit will scan the selected band for stations and the
2.
Rotate the TUNfTRK dial to tune in stations. Tuning au-
unit will stop at each station for 8 seconds, before con-
tomatically stops at a broadcasting frequency.
tinuing to the next station.
When tuned in to FM stereo broadcasting stations, the
Press the m again to stop Scan Tuning and remain
“ CT, ” stereo signal indicator will appear on the display
this on the selected frequency.
window.
fi< :
Lower Frequency.
Preset Scan Tuning
: Higher Frequency.
Manual Tuning
1
. Press the (si\NO) to select the desired AM or FM band.
2. Rotate and hold the TUNflRK dial for more than 0.5 sec-
ond to activate the manual tuning mode.
” MAN ” indicator will appear on the display window.
1.
2.
Press the (8*ND) to select the desired AM or FM band.
Hold the (ScIps) pressed for more than 2 seconds.
The unit will scan preset memory for the 12 stations from
the AM I/AM II band or the 18 stations from the FM I/FM
II/FM III bands. The unit will stop at each preset station
for 8 seconds, before continuing to the next preset sta-
tion.
Press the (SIRS) again to stop Preset Scan Tuning and
remain this on the selected frequency.
Rotate again to tune in to stations.
After 4 seconds of completing Manual Tuning, the tuning
Memorizing Stations Automatically
control will revert to the Seek Tuning mode.
(Travel Store)
1.
Press the (B/iND) to select the desired AM or FM band.
2. Hold the (BliND) pressed for longer than 2 seconds.
Up to 6 stations with strong signals will be automatically
stored in preset memory for the selected band.
If the radio is in FM
I
or FM
II,
it switches to FM
111.
If the
radio is in AM
1,
it switches to AM
II.
Note
This function is available for FM III and AM II.
Memorizing Only the Desired Stations
You can store up to 6 stations on each band (18 for FM
I,
FM
II
and FM III, 12 for AM I and AM II) in the order of your
choice.
1
. Press the (8*ND) to select the desired band.
2. Rotate the TUN/TRK dial to tune in stations.
3. Press and hold the desired preset memory button 0 -
0 for about 2 seconds until the frequency indicator
flashes twice.
I
The number of the pressed preset memory button ap-
pears on the display window.
Note
If when you store another station on the same preset number
button, the previously stored station is replaced with new one.
Receiving the Memorized Stations
1
. Press the <,,,,) to select the desired AM or FM band
2. Press the 0 - a momentarily.
Local/Distant (LOIDX) Selection
This feature is used to select the signal strength at which the
radio will stop during Seek Tuning.
Press the (MUTE for more than 2 seconds to select the
Local setting and only strong (local) stations will be received.
The “ lo ” indicator appears on the display window.
Pressing for more than 2 seconds again will select the Dis-
tant setting and the radio will stop at a wider range of signals,
including weaker more distant stations. The “ lo ” indicator
will go out on the display window. DX is the suggested default
setting.
E-5
To Next Page
Loading...
