53
ENGLISH
DEUTSCH
FRANÇAIS
ITALIANO
NEDERLANDS
SVENSKA
ESPAÑOL
PORTUGUÊS
External audio sources
In addition to the CD changer it is also
possible to connect another external au-
dio source to the line output. These
sources can include a portable CD play-
er, MiniDisc player or MP3 player.
If you have not connected a CD chang-
er, it is possible to connect two external
audio sources.
You must activate the AUX output in the
menu.
If you would like to connect another ex-
ternal audio source, you will require an
adapter cable. This adapter cable can
be ordered from any authorized Blau-
punkt dealer.
Switching the AUX output on/off
➮ Press MENU 8.
“MENU” will appear in the display.
➮ Press : repeatedly until “AUX-
IN-1 OFF” or “AUX-IN-1 ON” ap-
pears in the display.
In place of the “1”, there is a “2” for the
second AUX input. If you have connect-
ed a CD changer, then only AUX “2” can
be selected.
➮ Press or : to switch AUX on
or off.
➮ Once you have completed your
selections, press MENU 8 or
OK ;.
Note:
If the AUX input has been switched ON,
you can select it by pressing CD•C @.
TMC for dynamic navigation
systems
TMC stands for “Traffic Message Chan-
nel”. Traffic messages are transmitted
digitally via TMC and can then be used
by properly programmed navigation sys-
tems in route planning. Your car audio
system has been equipped with a TMC
output to which Blaupunkt navigation
systems can be connected. To find out
which navigation systems you can use
with your car audio system, contact your
specialist Blaupunkt dealer.
If a navigation system has been con-
nected and you have tuned into a TMC
radio station, TMC will light up in the dis-
play.
If dynamic route guidance has been
activated, the system will automatically
tune into a TMC radio station.
EXTERNAL AUDIO SOURCES TMC
To Next Page
Loading...
