Blaupunkt CDC-RF6 - 45° Installation; Set Anti-Vibration Switches; Attach Unit to Floor; Temporarily Remove Changer

45O Installation
l Confirm that Anti-Vibration
Switches on both left and
right sides are set to
position 45”.
l Attach brackets (L) and (R)
using the hexagonal bolts
(M5 x 8).
l Attach brackets (L) and (R)
to their respective
brackets (B) using the
hexagonal bolts (M6 x 20)
and the hexagonal nuts
(M6).
where to attach the unit.
l Stick the supplied double-sided tape
to the bottom of the brackets (B) and
peel off the paper backing.
l Affix the unit to the floor by pressing
in place.
l Remove the hexagonal nuts and
take off the changer.
directly above the brackets (B) bolts.
l Return the carpet to its original
position allowing the bolts to
protrude through.