21
Essen CR 43
DEUTSCH
ENGLISH
ITALIANO
PORTUGUES
NEDERLAND
ESPAGÑOL
SVENSKA
FRANÇAIS
Acoustic Alarm
When leaving the coverage area of the tun-
ed in traffic station, your car radio automati-
cally sends out an acoustic alarm after ap-
proximately 30 seconds.
This alarm tone can also be heard when
pressing a preset button with no ARI station
allocated to it.
Switching the Alarm Tone Off
a) Tune in another station providing traffic
information:
• press rocker switch 2 or
•a preset button on which a traffic
station is stored.
or
b) deactivate ARI preference:
• press the ARI rocker switch >.
Automatic Start of the Station
Seek Operation (Tape Playback)
When leaving the coverage area of the tun-
ed in traffic station, your car radio will auto-
matically start searching for a new traffic
station while you are listening to your tape.
Adjusting the Volume of Traffic
Messages and the Acoustic
Alarm
This volume has been set ex factory. Howe-
ver, you can adapt it according to your
personal preferences.
• Tune in to a traffic information station
(“SK” : is displayed).
Activate the ARI function by
• pressing the ARI rocker switch >.
• Turn the volume down.
Using a suitable screwdriver (maximum bla-
de width 2 mm), you can carefully (!) adjust
the volume while a traffic message is broad-
cast.
Tape Section
Inserting the Tape
If you wish to play a cassette tape:
• switch the set on.
• gently insert the cassette with side 1
upwards.
The tape will then be played in the direction
it was last played.
Track indication 6 indicates which side is
played.
- side A or 1 is played.
- side B or 2 is played (reverse opera-
tion).
Removing the Tape
If you wish to remove the tape:
• press the
button 4. The tape is
then ejected.
Fast Forwarding/Rewinding of
the Tape
Fast Forward
• Press the FF (Fast Forward) button 9.
At the end of the tape the set will switch
to the other side and resume playing.
Stopping the Fast Forward Operation
• Press the FR button 7.
ARI
To Next Page
Loading...
