Essen CR 43
14
Front Panel Description
1 ON/OFF
Switch the set on/off by turning the
knob.
If “Cod” appears on the display, read
the chapter “Anit-Theft Coding” first.
Volume control:
By turning the knob
SCAN (search operation):
During radio reception, the stations are
briefly sampled by pressing the knob for
approx. one second.
Balance:
Pull knob and adjust left/right volume by
turning the knob.
2
/ rocker switch
Radio: Automatical station tuning
Coding: Read first the “Anti-Theft
Coding” chapter.
: Press rocker switch
to confirm your code
entry.
3 << / >> rocker switch
For fine tuning of the stations
4
Ejection of the tape
5 Cassette compartment
6 Track indication
- side A or 1 is played
- side B or 2 is played (reverse ope-
ration)
7 FR button (Fast Rewind)
Fast rewinding of the tape.
Deactivate: press button FF.
8 PROG (Autoreverse)
For shifting to the other side of the tape
– press both buttons.
9 FF button (Fast Forward)
Fast forwarding of the tape
Deactivate: press button FR.
: Display for
; Button to fold out the QuickOut
handle
Only possible with QuickOut car radios.
< Preset buttons 1, 2, 3, 4, 5, 6
Store station - Keep button depressed
during radio operation until the station
becomes audible again.
Recall station - Briefly press the re-
spective button.
Coding - Read the “Anti-Theft Coding”
chapter first.
Buttons 1 - 4: Use to enter a code num-
ber.
Press each of the buttons until the code
to be found in the car radio passport is
represented on the display.
= lo rocker switch
Use this button to alter the sensitivity of
the automatic station seek operation.
“lo” lights up on the display - normal
sensitivity
“lo” does not light up - high sensitivity
Additional function of the lo rocker
switch:
Switching from stereo to mono:
Press longer than 2 seconds.
frequency
waveband
preset button
storage level
stereo
seek tuning
(sensitivity)
ARI preference
ARI station
identification
To Next Page
Loading...
