46
DEUTSCH
FRANÇAISITALIANO
NEDERLANDS
SVENSKAESPAÑOL
PORTUGUÊS
DANSK
ENGLISH
Tuning into a station
The IVTV-05 provides two options for setting the stations: The automatic station
seek tuning and the manual setting. In addition to that, the IVTV-05 provides the
opportunity of conveniently searching for new stations only without overwriting
the existing station list.
Automatic station seek tuning
With automatic station seek tuning, all previously stored stations are deleted and
the memory locations are reassigned.
1. Press the Menu button on the remote control.
E The menu of the IVTV-05 is displayed.
2. Move the selection mark with the M or N button to the Setup menu item and press the
OK button.
E The Setup menu is displayed, the Channels installation entry is selected.
3. Press the OK button.
E The Station Channels installation menu is displayed. Press the OK button.
4. Press the O or P button repeatedly until Full is displayed.
5. Press the OK button.
E A warning note is displayed.
6. If you want to start the scanning, press the OK button; if you do not want to start
the scanning, press the Exit button.
E If you pressed OK, the station seek tuning starts. After the scanning is complete,
the number of new stations is displayed.
7. Press the OK button.
E The menu is displayed again.
8. Press the Menu button to return to the menu. Press the button again to exit
the menu.
To Next Page
Loading...