Blaupunkt Kiel CD30 - User Manual

AUTORADIO
T-Line D/EU Funline2
Lübeck C30 Düsseldorf C50
7 640 105 510 7 640 205 510
Luxembourg C30 Bologna C50
7 640 110 510 7 640 210 510
Augsburg C30
7 640 115 510 Sylt CD50
Dublin C30 7 640 255 310
7 640 120 510 Modena CD50
Boston C30 7 640 260 310
7 640 125 510 7 640 260 312
7 640 260 315
Kiel CD30 7 640 260 318
7 640 155 310
Lausanne CD30 Colorado DJ50
7 640 160 310 7 640 405 019/...510
Alicante CD30 Carolina DJ50
7 640 165 310 7 640 410 019/...510
Dakota DJ50
Minnesota DJ30 7 640 460 310
7 640 315 019/...510
Ontario DJ30
7 640 320 019/...510
8 622 402 383 BN 03/00 AG
Serviceanleitung • Service Manual
UNSICHTBARE LASERSTRAHLUNG
NICHT DEM STRAHL AUSSETZEN
LASER CLASS 3B
CLASS 1
LASER PRODUCT
GB
CAUTION!
The CD units are equipped with a laser component!
For servicing make sure to observe the following
instructions:
- The unit operates with invisible laser beams.
- When the cover is removed, invisible laser beams are
emitted near the disc compartment.
- Avoid direct eye contact with these beams.
- Keep unauthorised persons away from the workbench.
- The viewing distance should not be less than 13 cm.
- If this distance cannot be kept, use suitable laser safety
goggles.
D
VORSICHT!
Die CD-Geräte beinhalten eine Laserkomponente!
Im Servicefall bitte nachfolgende Hinweise
beachten:
- Das Gerät arbeitet mit einem unsichtbaren Laserstrahl.
- Bei geöffnetem Gerät tritt im Bereich des Plattenfaches
Laserstrahlung aus.
- Nicht in den Strahl blicken.
- Unbeteiligte Personen vom Arbeitsplatz fernhalten.
- Der Betrachtungsabstand darf 13 cm nicht unterschreiten.
- Kann dies nicht eingehalten werden, muß eine geeignete
Laserschutzbrille getragen werden.

Summary

Laser Safety Precautions

General Laser Safety Warnings

Important safety instructions for servicing CD units with laser components.

Measurement Points and Alignment

Quickfit Connector Pin Assignment

Connector Pinouts (C-1, C-2, C-3)

Service Operations and Equipment

FM Alignment Procedures

FM IF Offset Programming

Steps to program the FM intermediate frequency offset.

FM Oscillator Alignment

Procedure to align the FM oscillator circuit using a digital voltmeter.

Advanced FM Alignment

Basic IF and RF Circuit Alignment

Aligning the IF and front/intermediate RF circuits for FM.

FM Phase-Shifter Alignment

Procedure to align the FM phase-shifter for optimal signal reception.

FM Alignment and IF Limiting

FM Alignment Window Adjustment

Adjusting the FM alignment window and checking symmetry.

IF Limiting Adjustment

Procedure to adjust the intermediate frequency limiting stage.

AM Alignment Procedures

MW Oscillator Alignment

Steps to align the MW oscillator circuit using a digital voltmeter.

MW Input Circuits Alignment

LW Oscillator Alignment

AM Alignment and LW;IF Adjustments

LW Input Circuit Alignment

AM IF Alignment

Product Parameter Programming

Lo FM Programming

Programming low-band FM frequencies in service mode.

Dx FM Programming

Advanced Parameter Programming

Stereo Threshold Programming

RDS Basic Sensitivity Programming

AM;LW Parameter Programming

Lo MW Programming

Dx MW Programming

Lo LW Programming

LW Parameter Programming

Dx LW Programming

Code and Start Up Programming

Authorized Decoding Agent Requirements

Details equipment and procedures for authorized decoding agents.

Blaupunkt Kiel CD30 Specifications

General

Power Output	4 x 50W
Tuner	FM/AM
CD Playback	Yes
USB Port	Yes
AUX Input	Yes
Bluetooth	No
DIN Size	1 DIN
Display Type	LCD
Detachable Face	Yes
MP3 Playback	Yes
Remote Control	Yes
Type	CD Receiver