36
➮ Press the MENU button 8.
➮ Keep pressing the or button 7 un-
til “LEARN KC” appears in the display.
➮ Press the button 7.
“CHANGE” appears in the display.
➮ Remove the first KeyCard.
➮ Insert the new KeyCard.
“LEARN OK” appears in the display.
To close the menu,
➮ press the MENU button 8.
The car radio can now be operated using the
second KeyCard.
Note:
● A maximum of two KeyCards can be
used for each device.
If you already have two KeyCards for the unit
and then prepare a third, the KeyCard that
was not inserted whilst the third KeyCard was
being prepared can no longer be used to op-
erate the unit.
Lost or damaged KeyCard
If all the unit’s KeyCards are damaged or lost,
you can prepare a new KeyCard.
You can acquire a new KeyCard from your
dealer.
Before you can use the new KeyCard, you
will need the device’s master code, which you
can find printed on the car radio passport. To
prepare a new KeyCard, please read the sec-
tion entitled “Preparing a new KeyCard”.
Keep the car radio passport in a safe
place but never in the vehicle.
Preparing a new KeyCard / entering the
master code
If you no longer have a valid KeyCard for your
unit and you want to prepare a new KeyCard:
➮ Insert a new KeyCard that the unit is not
yet familiar with.
➮ Close the control panel.
➮ Switch the unit off, if it is not already off.
➮ Simultaneously press and hold the
TUNE > and ST1 4 buttons.
➮ Switch the unit on using button 2.
“0000” appears in the display.
Enter the four-digit master code that is print-
ed on the car radio passport as follows:
➮ Enter the each of the master code’s
numbers using the
/ buttons 7. To
do so, repeatedly press the buttons until
the required number appears in the dis-
play.
➮ Move the input cursor using the
buttons 7.
➮ If the master code is displayed correctly,
press the OK button 5.
The new KeyCard is accepted as soon as
the unit switches to playback mode.
Visual theft protection (LED)
When the unit is switched off and the Key-
Card removed, the power-on button and drive
compartment illumination can be set to flash.
This requires the “LED” setting in the menu
to be set to “ON”.
➮ Press the MENU button 8.
➮ Keep pressing the or button 7 un-
til “LED ON” or “LED OFF” appears in
the display.
➮ Press the or button 7 to switch
between the ON and OFF settings.
THEFT PROTECTION
To Next Page
Loading...
