6
Placing the device in operation
Attaching the control panel
쏅 Push the control panel into the bracket at the
right edge of the device.
쏅 Push the control panel carefully into the left
bracket until it clicks into place.
Removing the control panel
쏅 Press the
button
1
to unlock the control
panel.
The left side of the control panel detaches
from the device and is secured by the bracket
against falling out.
쏅 Move the control panel slightly to the left until
it disengages from the right bracket.
쏅 Carefully remove the control panel from the
left bracket.
Note:
The car sound system automatically switches
o after approx. 10 seconds if the control
panel is removed.
Display language
You can de ne whether the language for messages
on the display is English or German. The setting is
performed in the user menu (see the chapter "User
settings", section "Making settings in the "DISPLAY"
menu", menu item " LANGUAGE").
Important note for radio reception
This car sound system is designed for operation in
di erent regions with di erent frequency ranges
and station technologies. Available reception
areas are "EUROPE", "ASIA", "NORTH AMERICA",
"SOUTH AMERICA" and "THAILAND".
You may have to set a suitable reception area rst
for the radio reception in the user menu (see the
chapter "User settings", section "Making settings
in the "TUNER" menu", menu item "TUNER AREA").
Switching on/o
Switching on/o with the On/O button
쏅 For switch-on, press the On/O button
3
.
The car sound system switches on.
쏅 To switch o the device, press and hold down
the On/O button
3
for longer than 2 sec-
onds.
The car sound system switches o .
Note:
If you switch on the car sound system while
the vehicle ignition is switched o , it auto-
matically switches o after 1 hour to preserve
the vehicle battery.
Switching on/o via vehicle ignition
The car sound system will switch o /on simulta-
neously with the ignition if the device is correctly
connected to the vehicle's ignition as shown in the
installation instructions and you did not switch
the device o by pressing the On/O button
3
.
Volume
Adjusting the volume
You can adjust the volume in steps from 0 (o ) to
50 (maximum).
쏅 Turn the volume control
4
to change the
volume.
Note:
If a telephone is connected with the car sound
system as described in the installation instruc-
tions, the car sound system is muted in case
of a phone call. During muting, the display
shows "TELEPHONE".
Muting the car sound system (Mute)
쏅 Brie y press the On/O button
3
to mute
the car sound system or to reactivate the pre-
vious volume.
While it is muted, the display shows "MUTE".
To Next Page
Loading...
