Troubleshooting table
39
Troubleshooting table
Problem Cause Solution
The Lucca does not work or
does not work correctly.
The operating system of the
Lucca is overloaded.
Press and hold the On/Off
switch for longer than 14 sec-
onds to perform a reset. The
Lucca is restarted.
Reset the factory settings (Set-
tings menu, page two). All per-
sonal settings will be deleted!
Reinstall the navigation soft-
ware using the enclosed DVD.
The display remains dark if I
switch on the Lucca.
The display may temporarily
loose its contrast after long and
heavy exposure to the sun and
high temperatures.
Place the Lucca in the shade for
approximately 10 minutes and
switch it on again.
At very high temperatures, the
Lucca switches off to protect
against overheating.
The battery is not suffi ciently
charged.
Fully charge the battery. The
complete charging time is ap-
prox. 3 hours.
The battery is empty, even
though I did not use the Lucca
for some time.
The Lucca continues to use a
small amount of energy if it is
switched off. Hence, the bat-
tery could be discharged after
a few days.
To obtain battery operation
of up to 3 hours in navigation
mode, completely charge the
battery for approx. 3 hours.
During short driving times,
the battery is not completely
charged.
Always operate the Lucca in the
vehicle together with the charg-
er cable via the cigarette lighter.
At very high temperatures, the
battery is not charged to protect
against overheating.
Place the Lucca in the shade for
approximately 10 minutes and
recharge the battery.
The Lucca does not respond
when I touch the buttons.
The operating system of the
Lucca is overloaded.
Press and hold the On/Off
switch for longer than 14 sec-
onds to perform a reset. The
Lucca is restarted.
Lucca3_5B_long_GB_NEU•.indd 39Lucca3_5B_long_GB_NEU•.indd 39 04.10.2007 16:49:41 Uhr04.10.2007 16:49:41 Uhr
To Next Page
Loading...
