BlindShell Classic 2 - Charging

7
To insert a SIM card, place it in a way that card contacts are facing downwards, and
its beveled edge is its upper left corner. Then slide the card into the slot.
Removing a SIM card
To remove a SIM card from a slot, place a tip of your nger on the edge of the SIM
card, push down on it and slide your nger with the SIM card out of the SIM card
slot.
Inserting an SD memory card
The SD memory card slot is the rightslot in the upper part of the battery compartment.
To insert an SD memory card, place it in a way that card contacts are facing downwards
and slide it into the slot. Push the card to overcome small resistance. Click sound will
signal that the card is xed in the slot.
Removing an SD memory card
To remove an SD memory card, push the card into the slot until the clicking sound
signals that the card is released. Then slide the card out of the slot.
Inserting the battery
To insert the battery, locate a protrusion on the edge of the battery. This protrusion
should point towards the top corner of the battery compartment. Slide the battery
from the top to the bottom into its compartment, it should t snugly.
Removing the battery
To remove the battery, use a groove located in the top right corner of the battery
compartment. Pull the battery upwards.
2.5 Charging
The phone can be charged via a USB cable or charging cradle. To use the charging
cradle, connect the USB Type-C cable to the cradle’s socket, which is on the back-
bottom part of the cradle. Place the phone in the cradle. The phone’s USB socket
should be face down. The rear side of the phone should rest on the cradle.
7 7
7 7