!
*%!
!
TAKING A MEASUREMENT
1. Push either the USER 1 or USER 2 button once to START the measurement.
2.”00” will blink on the LCD.
3. About 2-3 seconds later, the pressure will be reset. Then the cuff will begin to inflate and the pressure will be displayed.
4. This cuff will inflate automatically as the monitor detects that your body requires more pressure for measurement. The
BP will beep during measurement to indicate it is in progress. After displaying the measurement reading, the unit will
STOP by itself.
Note: The blood pressure monitor is a sensitive instrument. You should not move or talk while your monitor is measuring
your blood pressure. Remain quiet and relaxed with your arm still during a measurement. In case of discomfort or pain
during inflation, press any user button and the BP will STOP the measurement and deflate the cuff. Remove the cuff
immediately. If you see an error message, please refer to the Error Messages section to diagnose any possible problems
with the unit.
To Next Page
Loading...