!
*'!
!
MAINTENANCE
1. Do not use an alcohol-based solvent or cleaning agent to clean the device.
2. Clean the device with a soft, dry cloth.
3. Do not immerse the device or cuff in water.
4. Do not bend the cuff or sleeve, and do not wrap the sleeve inside-out.
5. Do not dismantle the device or cuff or try to repair the unit by yourself. If you have a problem, contact
the manufacturer.
6. Do not operate the unit under conditions of extreme temperature or humidity, or direct sunshine.
7. Do not shake the unit.
8. When storing, make sure the air tubing is wrapped so that there are no sharp bends. This will prolong
the life of the cuff.
Note: Manufacturer will make available on request circuit diagrams, component part lists, descriptions,
calibration instructions, or other information that will assist manufacturer’s staff or authorized
representative for repair.
To Next Page
Loading...