Blitz SBC i-D - Auto Peak; Ac; Wg; Contrast

DATA
AC / WG
- SBC I-D is capable of displaying up to 3
-
AC - Actuator Type Wastegate
DATA different optional displays. Capable of - WG - External Type Wastegate
displaying electronic outputs from - Refer to Page 3 and 4 for different types of wastegate
INPUT LINE
1 the ECU such as temperature, voltage,
-
To set, press MENU and go to Main Menu. Scroll to AC / WG,
LOW [ V ]
0.0 pressure, TPS, A/F, and etc. press enter and scroll to select. Press enter to set.
FIT
0.00 - Optional harness is needed to display
HIGH [ V ]
5.0 this feature.
UNIT
FIT
1.00 - SBC I-D has the ability to display 4 different types of boost pressure
UNIT
%
kg/cm
2
-76 cmHG ~ 2.50 kg/cm
2
kpa
-76 cmHG ~ 2.45x100 kpa
DATA
* To set up A/F, set up DATA
BAR
-30 inHG ~ 2.45 BAR
chart as shown below. PSI -30 inHG ~ 35.5 PSI
INPUT LINE
2
-
To set, press MENU and go to Main Menu. Scroll to Unit and
LOW [ V ]
0.0 LOW [ V ] 0.00 press enter. Scroll left or right to select Unit, press enter to set.
FIT
0.00 FIT 0.00
HIGH [ V ]
12.0
HIGH [ V ]
16.0
CONTRAST
FIT 200 FIT 16.0
-
To set, press MENU and go to Main Menu. Scroll to CONTRAST
UNIT
*C
UNIT
VOLT
and press enter. Scroll to adjust, press enter to set.
DATA
BRIGHT
-
To set, press MENU and go to Main Menu. Scroll to BRIGHT
INPUT LINE
3
Important
and press enter. Scroll to adjust, press enter to set.
LOW [ V ]
0.0 - Addition instructions are included in the
FIT
0.00 SBC I-D optional harness.
RESET
HIGH [ V ]
16.0
FIT 16
UNIT
Volt
AUTO PEAK
Auto Peak ON - Will automatically reset Peak Hold. Peak will
reset only when throttle is release after the vehicle -> EXECUTE
has been in boost for more then 2 seconds.
CANCEL
Auto Peak OFF - Peak Hold will retain the highest boost level
achieved.
1
Press MENU button, scroll down to RESET and press
-
To set Auto Peak, Press MENU and go to Main Menu. Scroll to enter to select.
Auto Peak, press enter and scroll to select. Press enter to set.
2
To select function, scroll down and press enter.
- To reset Peak hold, press both REC/STOP and MENU button at once.
NOTE:
It is recommended to reset the boost controller
if the unit is not functioning properly.
Page 9
ALL
RESET