Blocks One - Care and Maintenance; Cleaning and Lubrication; Cleaning the Nozzle; Updating the Firmware

Blocks One
3D Printer User Manual
www.blockstec.com | info@blockstec.com
8
&
CARE&AND&MAINTENANCE&
CLEANING&AND&LUBRIFICATION&
!
1. Depending!on!your!use!of!Blocks!one!3D!printer!its!advisable!to!clean!the!rods!using!
a!soft!fabric!cloth!at!least!once!every!two!months.!
2. After!cleaning!the!rods!apply!a!small!drop!of!sewing!machine!oil.!
!
CLEANING&THE&NOZZLE&
!
1. Press!the!Knob!and!go!to!Control!!Temperature!Nozzle.!
2. Rotate!the!Knob!to!select!220 ºC,!wait!until!it!reaches!the!tem pe ratu re.!
3. Remove!the!plastic!from!the!nozzle!using!a!pair!of!tweezers.!
4. Repeat!Step!1!and!select!0ºC.!
!
UPDATING&THE&FIRMWARE&
!
We! are! constantly! updating! the! firmware,! adding! new! features! and! correcting! bugs.! It’s!
advisable!to!keep!up!with!our!updates!subscribing!to!our!newsletter!and!our!facebook..!
!
1. Download!latest!firmaware!(http://www.blockstec.com/one.html).!
2. Install!ard u in o !IDE!(www.arduino.cc/en/main/software).!
3. Open!the!latest!firmware!using!arduino!IDE.!
4. Connect!usb!cable.!
5. Press!upload!on!arduino!IDE.!
6. When!the!process!is!complete!disconnect!the!usb!cable.!
7. You!have!just!updated!your!Blocks!one!firm w a re .!
! &