EasyManua.ls Logo

Blomberg WM72200W - User Manual

Blomberg WM72200W
76 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
WM72200W
Front-Loading Automatic
Washer
Owners Guide & Installation
Instructions
To prevent accidents and machine damage, read these
instructions before installation or use. Use the washer only as
instructed in this owner’s guide and installation instructions
included with your washer. Keep this guide for future reference
As an ENERGY STAR® partner,
BLOMBERG has determined that this
product meets the ENERGY STAR®
guidelines for energy efficiency.

Table of Contents

Other manuals for Blomberg WM72200W

Questions and Answers

  • S
    Suzanne SalazarAug 18, 2025
    Why won't my Blomberg WM72200W Washer loading door open?
    • M
      Michele BrownAug 18, 2025
      The loading door of your Blomberg washer may not open due to several reasons. The cover lock might be activated because of the water level inside; try draining the water by running the Pump or Spin programme. The washer might be heating water or in the spinning cycle; wait until it's over. The door can only be opened a few minutes after the program has stopped due to an electrical safety mechanism. If the child lock is engaged, wait a couple of minutes after the program ends for it to deactivate.
  • F
    frazierpennyAug 20, 2025
    Why can't I start or select a program on my Blomberg WM72200W?
    • D
      Dominique LittleAug 20, 2025
      The Blomberg washer may have switched to self-protection mode due to a supply problem (line voltage, water pressure, etc.). To cancel the current program, turn the Programme Selection knob to select another program.
  • O
    omortonAug 23, 2025
    What to do if my Blomberg Washer is not draining water or drains slowly?
    • E
      Elizabeth BradleyAug 23, 2025
      If your Blomberg washer isn't draining water or is draining slowly, check the drain hose for any folds and straighten it if necessary. Also, the drain pump filter or the drain itself may be clogged. Clean the drain pump filter.
  • T
    Thomas ConnerAug 26, 2025
    Why is my Blomberg WM72200W taking longer than specified in the manual?
    • E
      Emily RichardsonAug 26, 2025
      Several factors can cause your Blomberg washer to take longer than expected. Low water pressure causes the machine to wait until it has enough water, extending the wash time. Similarly, low supply voltage prolongs washing to ensure good results. Cold water temperatures require more time to heat the water. Also, the washer may increase rinse cycles or water amount for better rinsing. Excessive foam from too much detergent can also activate the foam absorption system, lengthening the cycle. Finally, an imbalanced load can trigger the spin correction system.
  • B
    Brittany DuarteAug 28, 2025
    What to do if my Blomberg Washer does not fill with water or wash?
    • J
      Jennifer JenkinsAug 28, 2025
      If your Blomberg washer isn't filling with water or washing, several issues could be the cause. First, ensure the water faucets are fully open. Check the water inlet hose for any folds and straighten it if needed. Also, inspect the water inlet strainers for clogs and clean them if necessary. Verify that the washer is plugged into a working electrical outlet and that the outlet has power. Examine the drain hose for folds, and make sure the loading door is properly closed. Note that in handwash, wools, or soak cycles, tumbling may not start immediately. Lastly, check the drain pump filter and drain for clogs.
  • K
    Kenneth RobinsonAug 30, 2025
    What to do if my Blomberg WM72200W Washer is vibrating or making noise?
    • C
      castillocourtneyAug 30, 2025
      If your Blomberg washer is vibrating or making noise, it could be due to several reasons. Ensure the washer is standing balanced by adjusting the feet. Check the pump filter for any hard substances and clean it if necessary. Make sure the transportation safety bolts have been removed. Adjust the laundry quantity, adding more if it's too little or removing some if it's excessive, and distribute the load evenly. Also, ensure the washer isn't leaning on anything.
  • R
    rebekah68Sep 2, 2025
    Why is there water leaking from the bottom of my Blomberg WM72200W Washer?
    • B
      brendabrownSep 2, 2025
      If you notice water leaking from the bottom of your Blomberg washer, check the inlet hose connections to ensure the strainers and rubber seals are solid and securely fitted. Make sure the end of the drain hose is tightly attached to the waste pipe or sink. Also, verify that the pump filter cap is tightly closed.
  • A
    alexandria38Sep 4, 2025
    Why does my Blomberg Washer have too much foam inside?
    • T
      Tanya DuranSep 4, 2025
      Excessive foam in your Blomberg washer can be caused by not using HE detergent or using too much detergent. Improper storage of detergent, such as in hot places, can also contribute. Additionally, washing meshed laundry like tulle can create excessive foam. Ensure the detergent is placed in the correct compartment.
  • T
    Tamara GreenSep 7, 2025
    What to do if my Blomberg Washer is overflowing with foam?
    • T
      Timothy GuzmanSep 7, 2025
      If foam is overflowing from the detergent drawer or your Blomberg washer is full of suds, it's likely due to not using HE detergent or using too much of it. Push the “Start/Pause/Cancel” button. Mix 2 cups of water with 1-2 tablespoons of fabric softener and pour it into the detergent dispenser. Push the “Start/Pause/Cancel” button again. Next time, use the proper amount of HE detergent.
  • A
    Andre RamirezSep 9, 2025
    Why does my Blomberg WM72200W Washer directly discharge the water it takes in?
    • R
      Rebecca DunlapSep 9, 2025
      If your Blomberg washer immediately discharges the water it takes in, the draining hose might not be at an adequate height. Connect the water draining hose as described in the operation manual.

Summary

Your Washer

Overview

Diagram and explanation of the washer's main components.

Important Safety Instructions

General Safety Precautions

Essential safety precautions to prevent accidents and ensure safe operation.

Installation Instructions

Removing shipping bolts

Detailed steps to remove transit bolts essential for washer operation.

Electrical Connection

Critical information on safe electrical hookup, including grounding requirements.

Water Supply Connection

How to correctly connect the hot and cold water supply hoses.

Drainage

Instructions for properly connecting the drain hose to prevent leaks and siphoning.

Operating Instructions

First Use

Steps to take before operating the washer for the very first time.

Loading the washer

Guidance on how to load the drum for balanced washing and optimal results.

Detergent Use and Dispensing

Information on selecting, measuring, and using detergents, softeners, and bleach correctly.

Selecting a Program and Operating Your Washer

User maintenance instructions

Cleaning the drain pump filter

Detailed guide on how to clean the drain pump filter and drain residual water.

Troubleshooting

Troubleshooting Common Issues

A comprehensive guide to diagnosing and resolving various problems encountered with the washer.

Blomberg WM72200W Specifications

General IconGeneral
Stylefront-loading
Colorwhite
Washer Capacity1.95 cu. ft.
Max Spin Speed1, 200 rpm
Number of Cycles15
Cycle Selections15 (cotton/normal, perm press, heavy duty, mixed fabric, allergen, rinse, spin + drain, tub sanitize, hand wash/wool, down wear, coolclean, delicates/dark, sportswear, organic wash, quick wash)
Number of Options5 (heavy soil, soak, extra rinse, anticrease+, child lock)
Temperature Settings5
Internal Heaterno
Control Paneldigital and knobs
Interior Lightno
Steamno
Overflow Safetyyes
Add Washno
Soak Settingsyes
Remote Controlno
Wi-Fino
Voltage120 volts
Frequency60 hz
Current10a
Weight and Dimensions IconWeight and Dimensions
Depth21 1/4 inch
Height33 5/64 inch
Width23 5/8 inch
Net Weight156.5 lbs.

Related product manuals