Blomberg WM 26110 NBL00

Questions and Answers

B
butlerantonioDec 1, 2025
Why does my Blomberg Washer cycle take so long?
- M
  melissa76Dec 1, 2025
  If the cycle time on your Blomberg washer is longer than expected, here are some possible reasons: * Water pressure may be low. The washer will wait until there is a sufficient amount of water, which may lengthen the cycle time to avoid poor washing results due to insufficient water. * Supply voltage may be low. Cycle time is lengthened to avoid poor washing results when the supply voltage is low. * Inlet temperature of water may be low. Cycle time lengthens to heat up the water when the inlet water is cold. Also, washing time can be lengthened to avoid poor washing results. * There may be an imbalance of load in the drum. The automatic spin correction system might have been activated due to the unbalanced distribution of the laundry in the drum. * Number of rinse cycles might h...
D
Deanna HarveyAug 25, 2025
Why won't my Blomberg Washer turn on?
- A
  Arthur BrooksAug 25, 2025
  If your Blomberg washer does not work and no light is on, check the following: * Is there power at the outlet? Call an electrician and have the power outlet / circuit breaker / fuse checked. * The washer might be unplugged. Plug the power cord to a live and grounded electrical outlet. * An extension cord may be used. Do not use an extension cord. * The “On/Off” button might have not been pressed. This button must be pressed.
M
Mary WrightAug 25, 2025
Why doesn't the time delay function work on my Blomberg WM 26110 NBL00 Washer?
- D
  Danielle SloanAug 26, 2025
  If the time delay function does not work on your Blomberg washer, the door may not be closed properly. Close the loading door.
G
garzalisaAug 27, 2025
What to do if my Blomberg WM 26110 NBL00 load is too soapy?
- A
  Antonio DavisAug 27, 2025
  If your load is still too soapy or the washer is full of suds at the end of the program: * You are not using HE detergent or using excessive amount of detergent. Do not unload the washer. Operate a quick wash cycle (e.g. Delicates, Wools) without any detergent. Add 1-2 tablespoon of fabric softener into main wash compartment of detergent dispenser during water intake. Use proper amount of HE detergent next time you operate the washer.
S
stevenduffyAug 28, 2025
Why are there oily stains on my laundry after washing in my Blomberg WM 26110 NBL00 Washer?
- J
  James PayneAug 28, 2025
  If oily stains appear on your laundry after washing in your Blomberg washer, consider these possibilities: * Oily accumulations of prior wash cycles on the drum may have stuck to the laundry. Washer must be operated empty at sanitary cycle with detergent. * The detergent may have been placed into the wrong compartment; the detergent may be mixed with the softener. Softener should not come into contact with detergent when being added.
P
pricemistySep 23, 2025
Why does my Blomberg WM 26110 NBL00 fill with water when I cancel a process?
- P
  Paula AdkinsSep 23, 2025
  If your Blomberg washer fills with water when a process is cancelled, there may be hot water inside the washer. For safety reasons, water should be cycled in and out a couple times.
J
Jerry CameronSep 18, 2025
Why did my Blomberg Washer stop shortly after starting?
- E
  Elizabeth EstradaSep 18, 2025
  If your Blomberg washer stopped shortly after the program cycle started, it can stop temporarily due to low voltage. It will resume operating when the voltage is back to the normal level.
E
Elizabeth WhiteSep 23, 2025
Why are the lights flashing on my Blomberg WM 26110 NBL00?
- M
  marissa23Sep 23, 2025
  If the “Washing” and "Start/ Pause/Cancel" lights are flashing after the program is started on your Blomberg washer, water may have been cut off, the faucets may be turned off, the water inlet hose may be folded, or the water inlet strainers might be clogged. You can restart your washer by pressing the "Start/Pause/Cancel" button for a short time after ensuring that the water is not cut off.
P
Paul JacobsSep 12, 2025
Why don't my clothes smell like fabric softener after washing in my Blomberg Washer?
- J
  Joshua HamptonSep 12, 2025
  If clothes are stiff and/or do not smell like the fabric softener after washing in your Blomberg washer, consider these possible causes: * Using insufficient amount of detergent. If the water hardness is higher, using insufficient amount of detergent can cause the laundry to become stiff in time. Use appropriate amount of detergent according to the water hardness. * Softener being released early. You may have added too much softener beyond max fill line. * The detergent dispenser might be problematic. Water may be siphoned (pulling the softener into the washer early) during the fill or rinse cycles.
Z
Zachary HigginsSep 9, 2025
Why do clothes get tangled in my Blomberg WM 26110 NBL00?
- T
  thompsondannySep 10, 2025
  If clothes get tangled too much in the drum when washing in your Blomberg washer, consider the following: * Excessive laundry might have been loaded in. Do not load the washer in excess. * Washing many items of the same type or size of clothes together. Load the wash drum with items of different sizes.

Summary

Your Washer

Washer Overview and Components

Identifies and describes the main external parts of the Blomberg automatic washer, including the detergent dispenser, loading door, and control panel.

Washer Specifications

Important Safety Instructions

Installation Instructions

Location, Clearances, and Stacking

Guidance on choosing the installation location, required clearances for undercounter/closet, and stacking options.

Connections and Setup Procedures

Steps for removing shipping bolts, leveling the washer, electrical connection, power, and water supply.

Drainage, Transportation, and Disposal

Instructions for drainage setup, installation checklist, safe transportation, and appliance disposal.

Operating Instructions

Setup, Preparation, and Loading

Steps for first use, laundry tips, sorting, preparing clothes, and loading the washer drum.

Detergent, Additives, and Water Management

Guidelines on using HE detergents, quantities, dispenser usage, softeners, bleach, and water consumption.

Cycle Selection and Program Operation

Using the control panel, selecting cycles, understanding the program table, wash cycles, and spin speed.

Auxiliary Functions, Time Delay, and Advanced Operations

Explanation of optional functions, time delay, modifying selections, adding laundry, and child-proof lock.

Program Control and Quick Daily Use Guide

Procedures for cancelling programs, recognizing the end of a cycle, and quick daily operation steps.

User Maintenance and Cleaning

Cleaning Components and Filters

Instructions for cleaning the detergent dispenser, door seal, drum, outer cabinet, water inlet strainers, and drain pump filter.

Descaling the Washer

Guide for descaling the washer to prevent scale buildup, maintain performance, and avoid component failure.

Troubleshooting Common Washer Problems

Blomberg Clothes Washer Warranty Statement

How to Get Service and Support

Blomberg WM 26110 NBL00 Specifications

General

Type	Freestanding
Capacity	6 kg
Spin Speed	1000 RPM
Energy Efficiency Class	A+++
Dimensions (H x W x D)	85 x 60 x 54 cm
Weight	65 kg
Color	White
Colour	White
Built-in display	Yes
Door colour	White
Drum material	Stainless steel
Maximum spin speed	1000 RPM
Delayed start timer	Yes
Child lock	Yes
Remaining time indication	Yes
Adjustable spin speed	Yes
Adjustable temperature	Yes
Water consumption per cycle	45 L
Width	60 cm
Noise Level (Washing)	59 dB
Water Consumption	45 L
Washing capacity	6 kg
Loading type	Front load