bloom 25 GPM - Installation Guidelines; Installation Parts and Materials; Pipe Assembly

To Next Page

To Previous Page

- 6 -

NOTE: The parts shown in Table 3 are offered as accessories to the DAB pump and are only

available for purchase with the US BLOOM 50.

Table 3. Power Converter

Image

QTY

Part Description

P/N

Step Up- Down Transformer

99E0-235

Adapter

99E0-234

INSTALLATION GUIDELINES

The site conditions unique to each irrigation reservoir, irrigation room, or commercial

greenhouse project, etc., should be carefully considered when identifying the BLOOM

installation location. Refer to the Location Requirements section for addition details.

The following guidelines are recommendations for tanks with intake structure submergence.

depths less than15 ft (4.5m).

Upon delivery, unscrew the shipping screws to remove the BLOOM unit from the shipping crate.

Inspect the BLOOM for any damage or loose parts that may have occurred during transport.

Hand tightens any loose parts, make sure don’t over tight.

Installation Parts and Materials

The parts and materials required to install the BLOOM include:

• 3/8 in wrench (US models) or 14mm wrench (EU models).

• 7/8 in wrench (US models) or 34mm wrench (EU models). Wrench required to install the

regulator kit.

Pipe Assembly