7
Decals &
Safety Signs
Clean or replace all safety
signs if they cannot be
clearly read and understood.
PART NO. BD13
Location: Unit,
right side
The Post Driver comes equipped with all safety signs in place. Their locations are shown in
this section. Read and follow their instructions and ensure their care:
• Keep safety signs clean and legible at all times.
• Replace safety signs that are missing, illegible, or damaged.
• Ensure replacement parts installed during repair have safety signs attached.
To install new safety signs, follow these steps:
1. Clean the area where the safety sign is to be placed.
2. Spray a little soapy water on the surface where the safety sign is to be placed.
3. Peel the backing from the safety sign, and apply it in the position shown.
4. Firmly press the safety sign, and squeeze out the air bubbles with a straight edge (e.g., a
credit card).
PART NO. 9875
Location: Unit, front
PART NO. DIG21
Location: Unit, right side
PART NO. BD-057
Location: Unit, front
PART NO. DIG14
Location: Unit, right side
PART NO. DIG16
Location: Unit, right side
PART NO. BD-060
Location: Quick attach plate, front
PART NO. DIG35
Location: Quick attach plate, front
To Next Page
Loading...