Blue Ox BX2258 User Manual

BX2258
2012-14 Honda CR-V
Installation Instructions
405-0244 Rev H Page 1 of 10 3/21/16
Please visit www.blueox.com for the latest version of these installation instructions.
Attachment Tab Height: 15-1/2”
Attachment Tab Width: 24”
Reference your vehicle owner’s
manual for manufacturer’s towing
specications.
Serial Number
If the front of your vehicle looks different than
this, please contact us at (402)385-3051.
!
Failure to read and follow these instructions
could result in separation of the towed vehicle
from the tow bar, causing property damage,
loss of towed vehicle, personal injury or death.
WARNING
Bolt Size Grade 5 Grade 8
1/4” 10 14
5/16” 19 29
3/8” 33 47
7/16” 54 78
1/2” 78 119
5/8” 154 230
3/4” 257 380
Bolt Torque Specications
Torque in Foot-Pounds for Inch Bolts
Bolt Torque Specications
Torque in Foot-Pounds for Metric Bolts
Bolt Size Grade 8.8 Grade 10.9
6MM 6 8
8MM 16 22
10MM 31 40
12MM 54 70
14MM 89 117
16MM 161 230
18MM 222 318
Please read BOTH these Installation Instructions and the General Information sheet prior to
installing or operating this equipment.
1. Blue Ox
®
towing products and accessories are
intended to be installed by Blue Ox
®
Dealers
who are familiar with our products and have the
equipment and knowledge necessary to do “t
work”. If needed, Blue Ox
®
Dealers can be found
at www.blueox.com or by contacting our Technical
Service Department at (402) 385-3051.
2. Many Blue Ox
®
baseplates are designed to
use existing holes and hardware to mount the
baseplate to the towed vehicle. Even though bolts
are there, do not assume they are adequate for
baseplate mounting. Always use the hardware
supplied in the hardware kit and existing hardware
as specied in the installation instructions.

Blue Ox BX2258 Specifications

General

Brand	Blue Ox
Model	BX2258
Category	Automobile Accessories
Language	English

Summary

Introduction and Safety Information

Critical Safety Warning

Crucial warning about potential consequences of improper installation or use.

Installation Guidelines and Notices

Accident and Damage Policy

Guidelines for handling baseplates after an accident or damage.

Fascia Removal Continuation

Step 7-8: Final Fascia Release and Disconnection

Pull fascia corners, release clips, and disconnect electrical connections.

Frame Preparation and Modification

Step 12: Cut and Notch Bumper Area

Cut bottom portion and notch driver side for clearance.

Step 13: Notch Radiator Mounts

Make notches on rubber mounts located next to the radiator.

Step 14: Remove Frame Nut

Remove a nut on the inside of the frame for baseplate clearance.

Baseplate Installation - Part 1

Step 17: Align and Finger-Tighten Bolts

Align baseplate holes and finger-tighten 8MM bolts with washers.

Step 18: Secure Side Hole Attachment

Insert bolt and nut plate into the side hole for attachment.

Baseplate Installation - Part 2

Step 19: Finalize Bolt Tightening

Secure bottom hole with nut plate and fully tighten all hardware.

Step 22: Drill for Breakaway Switch

Drill hole for breakaway switch, taking care not to drill into the radiator.

Product Warranty Information

Three Year Limited Warranty

Warranty Limitations and Exclusions