Blueant X6 - Page 6

Get to know your
DO NOT expose the X6
speaker to liquid whilst
playing or charging, as doing
so may be dangerous, and
result in permanent damage
to the speaker or charger.
outPUT POWER o EIACINPUT
ol O
/A
Mads in China
X6 - Back of speaker
Charging
The back of the speaker has the power port to plug in the supplied power cable. Please only use the supplied
power cable to charge the speaker. A full charge may take 5-6 hrs. The battery indicator light on the display
will turn RED while charging.
When fully charged the battery indicator light on the display will turn GREEN. The bottom right of the display
has a battery indicator to show the remaining charge left.
Power Switch
AC Mode
The speaker can be used in AC mode while charging. Simply select AC on the back of the speaker to turn the
speaker on and use it in AC mode.
Off
The middle position of the power switch is off.
Battery Mode
Once your speaker is charged, you can select Battery mode. If you unplug the power cable you will have to select
Battery mode to use your X6. If the X6 in on Battery mode and the power cable is plugged in, the X6 will continue
to top up its charge. On the front of the speaker is a display with a red light when charging. The light turns green
when fully charged.
There is a battery bar on the bottom right of the display to show how much battery is left. Each bar represents
33% charge. When playing back music, the volume will be the same on AC mode or Battery mode.
The play time will vary by the type of music, volume level, EQ, LED settings and environmental conditions. As a
guide you will get around 8 hrs of play time at 50% volume on LED LO1.
For continuous playtime, simply plug in the AC power cable to keep the party going.
Outport Port
This RCA output is used to enable connecting to external device for recording or other purposes.
Bass Invertor Tube
This improves the Bass output of the speaker.
Power On
When you power on the X6, the speaker goes to Bluetooth mode by default.