Blueant X6 - Page 8

Get to know your X6 - Top of speaker 2
Loop Button
This button can be in USB and SD Card playback modes, NOT in Bluetooth mode. Press once to
loop one song - display will show “ONE”. This will continuously play the current song. Press
once more to cancel loop one song mode - display should show “-ONE".
Press and hold for 3 seconds to loop all songs - display will show “ALL". This will play all songs
on the source and then start again. Press and hold for 3 seconds again to cancel loop all songs.
Display will show “-ALL". When LOOP is not selected, all songs will play once and then playback
will stop.
Skip Forward Button Skip Back Button
This is used to skip forward to the next track ~ This is used to skip back to the previous track in
in Bluetooth, USB and SD card playback Bluetooth, USB and SD card playback modes.
modes.
Play Button
Once you have paired your phone or source device, inserted a USB device or Micro SD card, you
can press the PLAY button to start playing back music. To pause music, simply press the play
button again.
Using the Microphones
The X6 has 32 levels of volume. To avoid feedback, please do not point the microphone at the speaker or bring the microphone within 30cm of
These are synchronized with a the speaker.
connected phone when using Bluetooth 1. Connect the cable to the microphone as per the below, Diagram A.
mode. The default volume is reset to
8 (25%) every time the X6 is powered on.
When you reach level 32 (100%), the X6
will announce “maximum volume”. 3. The microphone (s) feature an ON/OFF switch. Please ensure the microphone is in the ON position to use.
2. Plug one microphone into the icrophone port. To use the second microphone plug it into
guitar port.
*NB your phone may have volume 16 steps,
these match the same percentage of volume
on the X6. e.g. 16 (100% volume) on your Diagram A
phone is 32 (100%) on the X6. 8 (50%) on Insert microphone cable into the microphone
3 {
your phone is 16 (50%) on the X6. ?;;r;?avég in the diagram. Push until it clicks
Volume is not synchronized when using 5
AUX mode.