Bluedio T3 3RD Generation - Music Playback and Volume Controls; Advanced Call Features; Advanced Features and Troubleshooting; Alternative Audio Modes

!!Iii To end a call
When }'OU are on call, 1o end it press the MF Butlon once.
!!Iii To reject a call
When }'OU hear a ringtone, there is an incoming call. To reject it press and
hold the MF Butlon for 2 seconds.
!!Iii To redial the last number
Press the MF Button twice, }'OU will hear a beep and the redialing process
begins.
!!Iii Voice dial (must be supported by your mobile phone)
Press and hold the MF Button until }'OU hear a beep.
!!Iii Call waiting (must be supported by your mobile phone)
When }'OU are on call 1, and }'OU receive call 2:
1. To end call 1&answercall 2: Press the MF Button once
2. Toanswercall 2 and putcall 1 on hold: Press and hold the MF Butlon
until }'OU hear a beep
When }'OU are on call 2, and call 1 is on hold:
3. To switch back1ocall 1 and putcall 2 on hold: Press and hold the MF
Butlon until }'OU hear a beep
4. To switch back 1o call 1 & end call 2: Press the MF Butlon once
!!Iii Bluetooth playback and volume controls
*The headphones are playing music via Bluetooth.
Pause/Play: Press the Play/Pause Button once
Skip Forward: Press and hold the Vol+ Button
Skip Back: Press and hold the Vol- Button
Volume Up: Press the Vol+ Button once
Volume Down: Press the Vol- Button once
!!Iii Line-in music playback
1. Plug the included audio cable in1o the jack on the headphones.
2. Plug the included audio cable in1o the jack on }'OU' device.
Note: Make sure the headphones are turned off before using this feature.
!!Iii Line-out music sharing
1.Connect the headphones 1o }'Our phone via Bluetooth.
2.Connect the headphones 1o other wired headphones or amplifier.
!!Iii Turning 3D sound on/off (in Bluetooth mode)
ON: When the headphones are playing music, press the MF Button and
••• 5 •••
Vol+ Button together then release them immediately. You will hear a tone
and the 3D sound is on.
OFF: When the 3D sound is on, press the MF Button and Vol- Button
together then release them immediately. You will hear a tone and the 3D
sound is off.
!!Iii Clearing the headphones memory
1. Make sure the headphones have entered pairing mode. (See
instruction "Entering pairing mode")
2. Press the Vol+ Button and Vol- Button together then release the buttons
immediately. All Blueloolh devices are deared from the headphones.
••• 6 •••