bluelab pH Probe User Manual (English)

Questions and Answers:

J
Jason SanchezJul 28, 2025
Why is my bluelab pH Probe Measuring Instruments pH reading inaccurate?
- L
  Lindsey AlvarezJul 28, 2025
  Inaccurate pH readings from Bluelab Measuring Instruments can stem from several issues. The probe itself might be contaminated, so cleaning it and recalibrating is a good first step. Also, ensure your calibration solutions are accurate, replacing them if necessary, and wait for stable readings during calibration. The probe wick could be contaminated, blocked, or dry; hydrate it in KCl storage solution for up to 24 hours, avoiding the measurement of proteins or oils. In some cases, the pH probe may be damaged or old and require replacement. Recalibrating the pH probe might also resolve unreliable pH calibration.
K
Krista MedinaAug 2, 2025
What to do if my bluelab pH Probe Measuring Instruments calibration is unsuccessful?
- S
  smithevanAug 3, 2025
  An unsuccessful calibration of Bluelab Measuring Instruments with a low slope (less than 90%) can occur if the buffers are inaccurate, so replacing them is a good first step. Also, the glassware might not be clean, so cleaning the pH probe and then calibrating can help. In some cases, the glassware may be aged and beyond cleaning, requiring the probe to be replaced. Make sure the BNC fitting is dry by using a cloth to dry it.
K
Kyle HerreraAug 9, 2025
What to do if bluelab pH Probe show incorrect sample reading?
- T
  Taylor RobinsonAug 9, 2025
  If your Bluelab Measuring Instruments show an incorrect sample reading after a successful calibration, it might be due to a ground loop, which often occurs in process systems. You can verify this by removing the sample from its environment and taking a measurement. The system's electrical circuitry may need to be checked. Also, the probe wick could be blocked, requiring a probe replacement.
J
Justin BarrAug 15, 2025
Why are the readings jumping on my bluelab Measuring Instruments?
- D
  Daniel GonzalezAug 15, 2025
  If your Bluelab Measuring Instruments are showing readings that jump around, it could be due to a few reasons. First, check that the probe is correctly connected to the meter. Ensure the contact zone of the probe is immersed in the solution by at least 2 cm / 1”. Inspect the BNC fitting and cable for any signs of damage that could indicate an electrical short.
N
nklineAug 21, 2025
How to fix bluelab Measuring Instruments pH reading that does not change?
- E
  Emily CookAug 21, 2025
  If the pH reading on your Bluelab Measuring Instruments isn't changing when you switch between solutions, it could be due to a broken glass bulb, tube, or connector on the pH probe. Inspect the pH probe for any signs of damage and replace it if necessary.