What to do if bluelab Measuring Instruments Truncheon Meter is not lighting?
If your Bluelab Measuring Instruments Truncheon Meter isn't lighting up when dipped in solution, try cleaning the probe. If cleaning doesn't solve the issue, replace the batteries. Remember not to use rechargeable batteries.
What to do if bluelab Measuring Instruments Truncheon Meter not lighting?
If your Bluelab Measuring Instrument Truncheon Meter isn't lighting up when you dip it in the solution, try cleaning the probe first. If cleaning doesn't solve the problem, replace the batteries. Remember not to use rechargeable batteries.
How to fix bluelab Measuring Instruments Truncheon Meter that turns off too quickly?
If your Bluelab Measuring Instruments Truncheon Meter turns off before you can get a reading, take it out of the solution for 3-5 seconds, then dip it in again and take your reading.
How to fix bluelab Measuring Instruments Truncheon Meter that turns off before reading?
If your Bluelab Measuring Instrument Truncheon Meter turns off before you can get a reading, take it out of the solution for about 3 to 5 seconds. Then, dip it back in the solution and try taking the reading again.
Place probe into nutrient solution and take reading as indicated by flashing lights.
Detailed steps for cleaning the Truncheon Meter probe and shroud using specific cleaners.
Steps to safely remove old batteries, check for corrosion, and install new batteries.
Correction for the meter turning off before a reading is taken.
General| Auto On/Off | Yes |
|---|---|
| Waterproof | Yes |
| Operating Temperature | 0 - 50 °C |
| Units of Measurement | EC, CF, ppm |
| Resolution | 0.1 EC 1 CF |
| Power Source | 3 x AA alkaline batteries |
| Length | 407 mm |
To Next Page
