5.2.2 Car charging
Ensure the following two conditions are met when using car charging:
• Power can be output from the vehicle.
• The engine of the vehicle is running.
Connect one end of the cable to the charging port of X60, and the other end to a
cigarette lighter port of the car. The charging will automatically stop when the battery is
fully charged.
Note:
(1) X60 cannot be powered off when it is being charged.
(2) The figure indicates that an adaptor is connected but X60 is not being
charged, and it can be turned off.
(3) The figure indicates that there is an overvoltage of the adaptor. Please
confirm it is the original adaptor of X60.
(4) Restriction of secondary charging : When X60 is charged to 100% and the adapter is
kept connected, it will only be recharged when the battery level drops to 95%. There is no
such restriction if the adapter is replugged.
JUST POWER ON14
To Next Page
Loading...
