EN
6
BluFilter manual
1.D APPLICATION
This product is only suitable in freshwater with a water temperature of +4°C to +35°C, in ponds and
water features. Not suitable for sea (salt) water and/or liquids to which the product is not resistant (e.g.
chemical liquids).
The BGF filter sets are for cleaning pond water and are installed in the pond. The maximum immersion
depth is 2.0 metres. Place the filter at least 10 cm below the water surface to prevent the intake of air.
2. SAFETY
Caution! Operation of this pump is only permitted if the existing electrical
installation complies with legal standards.
The filter must never be in operation when there are people in the water! (Disconnect filter from mains).
The filter should only be connected to an installation with a residual current device (30mA) and an
earthed socket.
The socket should be placed in a moisture-free place, at least 2 metres from the water’s edge.
The filter is equipped with a built-in UV-C lamp: UV-C radiation is harmful to eyes and skin: Avoid direct
contact with the lamp. It should only be in operation when the lamp is inserted in the housing and set
up in the pond.
If in doubt, consult a competent installer.
People who cannot follow these instructions must not operate the pump!
This device is not intended for use by persons and children with physical, sensory or mental impair-
ment, or lack of experience and/or knowledge.
Unless they are accompanied by a person responsible for their safety, or by being instructed how to
use the device.
Care must be taken to ensure that children cannot play with the device.
When doing any work on the filter and/or pond or other system, with which the filter is connected, first
remove the mains plug of the filter from the socket and any other devices that are connected.
Keep the plug free of moisture. To prevent water from running through the cord to the plug, form a loop.
Before putting the filter into operation, examine the power cord and plug for damage.
If the power cord, pump or UV-C lamp is damaged, the filter should no longer be used.
Repair is not possible as the cable is firmly cast into the motor and therefore not replaceable.
Never move or hang the filter by the power cord.
To Next Page
Loading...