© 2016 Blum, Inc. Subject to technical modifications without notice
22
Cover cap
Battery replacement
▀ When battery power begins to weaken, the SERVO-DRIVE switch battery display flashes red
▀ Only use type CR2032 batteries from known manufacturers
▀ Make sure that the new battery is inserted correctly (note proper pole connections +/-)
▀ The SERVO-DRIVE switch battery cannot be recharged
▀ If the battery is inserted incorrectly, the SERVO-DRIVE switch battery display will flash red
▀ Remove battery carrier tray by pressing
up or down on the battery display switch
▀ Remove dead battery ▀ Replace battery carrier tray into
switch housing
▀ Insert new battery
1
1
2
2
3
4
Cover Cap and Battery ReplacementSERVO-DRIVE for
AVENTOS
To Next Page
Loading...