BLUM SERVO-DRIVE Problem Resolution

Problem Possible cause Remedy
6 Pull-outwill not fully
close.
Pull-out is blocked by an
object.
➢ Remove object.
Fronts are rubbing against
each other.
➢ Reset gap design.
Slide-on technology:
Locking device height adjustment
Slide-on and clip-on feature:
Front tilt adjustment
Clip-on feature:
Height adjustment for full exten-
sion
Clip-on feature:
Height adjustment for single
extension
Bracket profile and/or attach-
ment bracket is positioned
incorrectly.
➢ Correct position of bracket profile
and/or attachment bracket.
Drive unit is positioned incor-
rectly.
➢ Correct position of drive unit.
Drive unit error. ➢ Reconnect drive unit and activate
eject lever.
➢ Replace drive unit and activate
eject lever.
MA-310/1-S-EN 06.11
Problem resolution
We recommend the following troubleshooting sequence.
Julius Blum GmbH
Furniture Fittings Mfg.
6973 Höchst, Austria
Tel.: +43 5578 705-0
Fax: +43 5578 705-44
E-mail: info@blum.com
www.blum.com
1
2

BLUM SERVO-DRIVE Specifications

General

Brand	BLUM
Model	SERVO-DRIVE
Category	Servo Drives
Language	English