What does E2 code mean on my Blyss A018I-12C?
If the 'E2 Code' appears on your Blyss Air Conditioner, it means the water tank is full during cooling. To resolve this, simply take off the rubber stopper and empty the water tank.
Why is my Blyss A018I-12C Air Conditioner not cool enough?
If your Blyss Air Conditioner isn't cooling effectively, ensure all windows and doors are closed to prevent warm air from entering. Remove any heat sources from the room. Check that the exhaust air hose is properly connected and not blocked. Also, verify that the temperature setting isn't too high, and make sure the air inlet is clean and unobstructed.
What to do if my Blyss A018I-12C does not start?
If your Blyss Air Conditioner unit doesn't start when you press the on/off button, it could be due to a couple of reasons. First, check if the water full indicator lamp is blinking, indicating a full water tank; if so, empty the tank. Secondly, if you are in cooling mode, the room temperature might be lower than the set temperature. In this case, try resetting the temperature.
What to do if my Blyss Air Conditioner shows E4 code?
If your Blyss Air Conditioner displays the 'E4 Code', it indicates that the water tank is full during heating. Please empty the water tank to resolve this issue.
What to do if the water full indicator lights up too often on my Blyss A018I-12C?
If the water full indicator on your Blyss Air Conditioner lights up frequently, even shortly after you've drained it, the water splash motor might be damaged. Consider repairing or replacing it.
Why is my Blyss Air Conditioner so noisy?
If your Blyss Air Conditioner is excessively noisy, first check whether the unit is placed on a flat, level surface. If it's not, try to reposition it. However, if the noise sounds like flowing refrigerant, this is normal.
What does E0 code mean on Blyss A018I-12C Air Conditioner?
If your Blyss Air Conditioner displays an 'E0 Code', it indicates a failure of the room temperature sensor. You can replace the sensor, but the unit can still operate without it.
What does E1 code mean on my Blyss Air Conditioner?
If your Blyss Air Conditioner shows an 'E1 Code', it means the condenser temperature sensor has failed. The solution is to replace the condenser temperature sensor.
What does E3 code mean on my Blyss A018I-12C Air Conditioner?
If your Blyss Air Conditioner displays an 'E3 Code', it indicates that the evaporator temperature sensor has failed and needs replacing.
Read the following instructions carefully before using the air conditioner and retain them for future reference.
Details the color coding for the wires in the mains lead and their connection terminals.
Steps for connecting the exhaust hose for temporary window installation.
Details on installing the window slider kit for different window types.
General| Brand | Blyss |
|---|---|
| Model | A018I-12C |
| Category | Air Conditioner |
| Language | English |
To Next Page
