BMC F2 - Fitting the Mask

F2 Full Face Mask User Manual V2.1
6 / 14
English
Fitting the Mask
Use a standard conical connector if pressure readings and / or
supplemental oxygen are required.
1
2
3
Pass the upper straps
of the headgear
through the installation
hole of the mask as
shown in the figure
and secure it, repeat
the process with the
lower straps.
Place the mask on the
face and extend the
headgear to the back
of the head / Please
confirm that the label
on the back of the
headgear faces
outward when the
headgear is worn.
Bring the lower-half
straps beneath the
ear and encircle the
face and then insert it
into the fixed hook on
the lower-half part of
the mask frame.
4
5
6
Extend the upper-half
straps of the headgear
as shown in the above
figure until the mask is
fixed properly.
Repeat the process for
the lower-half
headgear as shown in
the above figure until
the mask is fixed
properly.
Open the device for
the air supply. Attach
the respiratory hose
with the connector on
the base of the mask.
Adjust the position of
the mask to confirm a
tight seal.