To Next Page

To Previous Page

- Slide the fork on top of the crown race (4) and insert the steer tube from the bottom up (5). Tighten the steer tube to 8 Nm with 8mm

Allen ratchet wrench (6).

- Push in slotted sleeve (7), install top cap and bolt. Tighten lighly to preload the bearings (8).

- Lightly tighten the fork clamp (9) (4mm Allen, max torque 2.0 Nm).

4 5 6

Building a timemachine

Questions and Answers:

Need help?

Do you have a question about the BMC TMR01 and is the answer not in the manual?

BMC TMR01 Specifications

General