BMG LABTECH SPECTROstar Nano Operating Manual
2012-07-18 0601B0001C 7/16
2 Safety Information
Description of warnings 2.1
The warning signs used throughout this manual adhere to the description set forth in DIN 4844-2.
A general warning calls attention to a condition which is further described and must be
strictly followed by the operator
Warning for optical radiation
General Information 2.2
This instrument must be installed and used as lined out in this Operating Manual.
Installation, service and any operation which requires opening the instrument must be
performed only by trained and certified personnel from BMG LABTECH. Failure to
comply with these instructions will impair or even invalidate the warranty and can lead
to unsafe operation of this equipment
The area designated for the instrument should be free of dust, liquids and acidic
vapour. The surface of the table should be flat and even. Avoid areas subject to
vibrations and direct sunlight
Prior to turning the instrument on the first time let the instrument adapt to room
temperature for at least 3 h to avoid condensation causing a short circuit.
BMG LABTECH will void the warranty if damage occurs to electrical and/or mechanical
parts in case the instrument was turned on before the recommended accommodation
Handling and operation of the equipment must be carried out only by qualified
personnel and staff trained by an official BMG LABTECH representative
Samples and reagents, be it in solid, liquid, or gaseous form, must be removed from
the instrument immediately after measurement to avoid corrosion and accumulation of
hazardous substances inside the instrument
To Next Page
Loading...
