15
INSTALLATION INSTRUCTIONS
MAINS CABLE
The J35 is pre-cabled and fitted with a mains plug. Ensure that the connections
to the mains supply are in accordance with the national wiring rules, and that the
earth connection is installed.
The plug must be accessible during installation. If it is not possible, an
accessible mains disconnection switch must be incorporated in the mains wiring
where the plug is connected.
MOUNTING THE J35
The J35 should be securely mounted to a suitably rigid surface, using four pre-
drilled mounting holes.
It is recommended the mounting holes are located so that there is a minimum
of 80mm free air space from all vented sides of J35. This allows for the lowest
operating temperature of the internal electronics and the highest reliability of
the product.
The final enclosure must provide adequate ventilation to the outside world
(or larger internal cavity) to prevent excessive heating of the air within the
enclosure.
To Next Page
Loading...
Need help?
General
