Symbol Description
Vehicle symbol and distance bar
flash red and an acoustic signal
sounds:
Brake and take evasive action if
necessary.
System interrupted.
Displays in the Head-Up Display
Desired speed
Some information from the system can also be
shown in the Head-Up Display.
The symbol is displayed when the set
desired speed has been reached.
Distance information
The symbol is shown if the distance from
the vehicle in front is too close.
The distance information is active under the
following circumstances:
▷ Active Cruise Control switched off.
▷ Display in the Head-Up Display selected.
Head-Up Display, see page 196.
▷ Distance too close.
▷ Speed above approximately 70 km/h,
40 mph.
Preventing overtaking
This function helps to prevent inadvertent over‐
taking on motorways.
Depending on the equipment and the national-
market version, the system can be configured to
prevent overtaking in the slower driving lane.
The setting applies to speeds over
80 km/h/50 mph.
If the set speed is significantly higher than the
speed in the adjacent lane, it may be possible to
pass or overtake other vehicles even if the func‐
tion is switched on.
At speeds below 80 km/h/50 mph, vehicles on
motorways are only overtaken with an adapted
differential speed.
The driver can overtake or accelerate at any time
by pressing the accelerator pedal.
Switching the function on/off:
1.
"CAR"
2. "Settings"
3. "Driver assistance"
4. If necessary, "Driving"
5. "Speed Assistant"
6.
▷ "Avoid overtaking at the left side"
▷ "Avoid overtaking on the right"
System limits
System limits of the sensors
For further information:
▷ Cameras, see page 47.
▷ Radar sensors, see page 48.
Detection range
The system's detection capability and automatic
braking capacity are limited.
Seite 262
CONTROLS
Driver Assistance Systems
262
Online Edition for Part no. 01405A1EA53 - X/20
To Next Page
Loading...
