Emergency unlocking
The charging cable is locked when the vehicle is
locked and during the charging process.
Charging cable can be unlocked manually if there
is electrical defect.
1. Open bonnet.
2. Release the knob from the holder.
3. Pull the knob.
Charging cable is manually unlocked.
4. Remove charging cable.
Removing, see page 359.
After the charging cable has been unlocked in an
emergency, have the locking system of the
charging connection checked at a Service Part‐
ner of the manufacturer or another qualified
Service Partner or a specialist workshop.
Charging
General
At high or low outside temperatures, preheating/
precooling of the high-voltage battery can result
in longer charging times.
If the mode 2 charging cable is exposed to high
temperatures and direct sunlight, this may inter‐
rupt the charging process. Charging resumes au‐
tomatically.
The charging process will be interrupted or will
not be started when a Remote Software Up‐
grade is installed. The charging process may not
be continued automatically after successful in‐
stallation.
Safety notes
WARNING
Incorrect use of the power system connection
can lead to damage, for example cable fire.
There is a risk of injury or material damage.
Only use the charging cable for charging the
vehicle and do not extend it with a cable or
adapter.
WARNING
If the charging current intensity is set incor‐
rectly, the power system of the domestic
socket can be overloaded and overheat. There
is a risk of fire. Before charging at domestic
socket outlets, adapt the charging current in‐
tensity to the power system. Set to the lowest
level if the power system is unknown.
WARNING
An incorrectly connected charging cable can
lead to damage, for example cable fire. There is
a risk of injury or material damage. Ensure that
the charging cable plug has been fully inserted
into the socket.
Starting charging
1.
Engage the selector lever in position P. Apply
parking brake if necessary.
2. Plan the charging process.
Planning to charge, see page 361.
3. Switch off drive-ready state.
4. If necessary, connect the mode 2 charging
cable to the domestic socket outlet or the
mode 3 charging cable to the connection
point on the AC charging station.
5. Open charge point flap.
6. Connect charging cable to the vehicle.
Seite 360
MOBILITY
Charging vehicle
360
Online Edition for Part no. 01405A1EA53 - X/20
To Next Page
Loading...
