BMW K1300R Rider's Manual

The cable of the wheel-
speed sensor could chafe
through if it comes into contact
with the brake disc.
Make sure that the sensor
cable is routed correctly.
Clip on two retaining clips 1
holding the sensor cable to the
brake line.
Remove the adhesive tape
from the wheel rim.
Firmly pull the handbrake lever
until the pressure point is per-
ceptible, and repeat this opera-
tion several times.
Position covers 2 on left and
right.
Install screws 1 on left and
right.
Removing rear wheel
Place the motorcycle
on an auxiliary stand;
BMW Motorrad recommends
the BMW Motorrad rear-wheel
stand.
Install the rear-wheel stand
( 114).
with centre stand generation
II
OA
Make sure the ground is level
and firm and place the motor-
cycle on its centre stand.
Risk of burns caused by the
hot exhaust system.
Do not touch the exhaust system
when it is hot; if necessary, allow
the exhaust system ample time
to cool before proceeding.
Remove three screws 1 from
silencer cover 2.
Remove the cover.
9
109
z Maintenance

BMW K1300R Specifications

General

Displacement	1293 cc
Transmission	6-speed
Fuel Capacity	19 liters (5.0 US gal)
Seat Height	820 mm (32.3 in)
Bore x Stroke	80 mm x 64.3 mm
Compression Ratio	13.0:1
Fuel System	Electronic fuel injection
Final Drive	Shaft
Rear Brake	Single 265 mm disc, 2-piston caliper
Front Tire	120/70 ZR17
Rear Tire	180/55 ZR17
Dry Weight	217 kg (478 lb)
Engine Type	Liquid-cooled, 4-stroke in-line four-cylinder
Power	173 hp (129 kW) at 9, 250 rpm
Torque	140 Nm at 8, 250 rpm
Weight	243 kg
Front Suspension	Duolever
Rear Suspension	Paralever
Front Brake	Dual 320 mm discs, 4-piston calipers