Replacing bulb for front
and rear turn indicator
Switch off ignition ( 30).
Make sure ground is level and
firm and park motorcycle.
Remove screw 1.
Pull glass on screw connection
side out of light housing.
Remove bulb 1 from
light housing by turning it
counterclockwise.
Replace defective bulb.
Bulbs for flashing turn
indicators, front
RY10W / 12 V / 10 W
Bulbs for flashing turn
indicators, rear
RY10W / 12 V / 10 W
To prevent contaminants from
being deposited on the glass
surface, always use a clean, dry
cloth to hold the bulb.
Install bulb 1 by turning clock-
wise in light housing.
8
89
z
Maintenance
To Next Page
