BMW S 1000R 2018 User Manual

Displaying times
To display desired time, press
button 1 repeatedly until
display changes.
Start time recording
Operate switch 1 to start
recording.
NOTICE
For the headlight flasher signal
to be detected, the engine must
be running and the motorcycle
moving.
When driving over Start/Finish
line, operate switch 1 again to
start recording for next race
lap.
The data of the preceding race
lap will be saved.
If the display mode is exited
during a recording, then the
recording continues to run.
However, in the other display
modes the recording of a new
lap can only be started via an
external signal.
Infrared receiver
with infrared receiver
OA
The lap timer can be conve-
niently operated with an infrared
signal. For this purpose, infrared
receivers available as optional
accessories must be connected
to the IR receiver (on right-hand
side behind side panel). In the
RACETRACK SETUP MENU menu,
a setting can be made to define
whether operation is to be car-
ried out with the headlight flasher
button and TRIP/INFO button
or only with one of the two (see
SETUP MENU chapter).
7
98
z On the racetrack

BMW S 1000R 2018 Specifications

General

Torque	114 Nm at 9, 250 rpm
ABS	Standard
Traction Control	Standard
Power	165 hp (121 kW) at 11, 000 rpm
Transmission	6-speed constant mesh
Rear Suspension	Aluminum swing arm, adjustable compression and rebound damping
Front Brake	Dual 320mm discs, 4-piston calipers
Rear Brake	Single disc brake, diameter 220 mm, single-piston floating caliper
Seat Height	814 mm
Fuel Capacity	17.5 liters
Weight	205 kg (wet weight)
Front Suspension	Upside-down telescopic fork, adjustable compression and rebound damping