EasyManua.ls Logo

BMW X1 - Page 118

BMW X1
392 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
R reverse
Engage selector lever position R when revers-
ing. Engage reverse gear only when the vehi-
cle is stationary.
The vehicle drives off slowly when the brake
pedal is released.
N Neutral
The vehicle may be pushed or roll without
power, for instance in car washes, in selector
lever position N.
Parking position P
General information
In selector lever position P, the drive is blocked
by the transmission, e.g., for parking the vehi-
cle.
P is engaged automatically
Selector lever position P is engaged automati-
cally in situations such as the following:
After drive-ready state is switched off, if
selector lever position R, D, S, or L is en-
gaged.
After standby state is switched off, if selec-
tor lever position N is engaged.
The driver's seat belt is unbuckled and the
driver's door is opened while the vehicle is
stationary and selector lever position D, S,
L, or R is engaged.
Before exiting the vehicle, make sure that se-
lector lever position P is engaged and the
parking brake is engaged. Otherwise, the vehi-
cle may begin to move.
Additional information:
Parking brake, refer to page 125.
Engaging selector lever positions
General information
To prevent the vehicle from creeping after
you select a gear position or reverse, main-
tain pressure on the brake pedal until you are
ready to drive off.
Functional requirements
Only when the drive-ready state is switched on
and the brake pedal is depressed is it possible
to change from selector lever position P to an-
other selector lever position.
Selection lever position P cannot be disen-
gaged until all technical prerequisites are met.
Engaging selector lever position D, N,
R
1.
Fasten the driver’s seat belt.
2. To engage a selector lever position, pull or
push the selector lever in the desired direc-
tion, past a resistance point if necessary.
The selector lever automatically returns to
the center position when released.
Engaging selector lever position P
To engage selector lever position P,
press the parking brake button on the
center console.
Seite 118
CONTROLS
Driving
118
Online Edition for Part no. 01405A8A536 - VI/23