BMW X1 - Page 140

Tachometer
General information
Always avoid engine speeds in the red warning
field. In this range, the fuel supply is reduced to
protect the engine.
Activating/deactivating the
tachometer
The tachometer is displayed depending on the
selected drive mode or the individually config-
ured layout.
The tachometer display changes depending
on the selected driving mode.
Reduced engine speed range
The reduced speed range may be due to cer-
tain factors, e.g., a cold drive system. The
tachometer display is automatically adjusted
depending on the available engine speed
range.
In addition, icons in the tachometer indicate a
reduced speed range.
Standby state and drive-
ready state
If OFF is displayed in the instru-
ment cluster, drive-ready state
is switched off and standby
state is switched on.
If READY is displayed in the in-
strument cluster, the Auto Start/
Stop function is ready to start
the engine automatically.
Additional information:
▷
Operating condition of the vehicle, refer to
page 39.
▷ Auto Start/Stop function, refer to page 115.
Engine temperature
The engine temperature is displayed in the in-
strument cluster.
▷ If the engine is cold, the nee-
dle is in the blue temperature
range, close to the limit po-
sition of the temperature dis-
play. WARM-UP is also dis-
played.
Drive at moderate RPM and
vehicle speeds.
▷ At normal operating temperature, the nee-
dle is in the middle or in the left half of the
temperature display.
▷ If the engine is hot, the needle is in the
red temperature range. In addition, a Check
Control message is displayed.
Additional information:
Coolant level, refer to page 348.
Display
The engine temperature is displayed in the in-
strument cluster.
▷
If the engine is cold, the nee-
dle is in the blue temperature
range, close to the limit po-
sition of the temperature dis-
play. WARM-UP is also dis-
played.
Drive at moderate RPM and
vehicle speeds.
▷ At normal operating temperature, the nee-
dle is in the middle or in the left half of the
temperature display.
▷ If the engine is hot, the needle is in the
red temperature range. In addition, a Check
Control message is displayed.
Additional information:
Coolant level, refer to page 348.
Seite 140
CONTROLS
Displays
140
Online Edition for Part no. 01405A8A536 - VI/23