BMW X1 - Page 159

Activating rain sensor
To activate the rain sensor: Push the wiper
lever upward from position 0, arrow 1, once.
Wiping operation is started.
The LED in the wiper lever is illuminated.
In frosty conditions, wiping operation may not
start.
Deactivating rain sensor
To deactivate the rain sensor: Push the wiper
lever back to position 0.
Adjusting the rain sensor sensitivity
To adjust the sensitivity of the rain sensor,
turn the knurled wheel on the wiper lever as
follows:
▷
To set the rain sensor sensitivity to high,
turn the knurled wheel up.
▷ To set the rain sensor sensitivity to low,
turn the knurled wheel down.
Windshield washer system
Safety information
Warning
The washer fluid can freeze onto the window
at low temperatures and obstruct the view.
There is a risk of accident. Only use the
washer systems if the washer fluid cannot
freeze. Use washer fluid with antifreeze, if
needed.
NOTICE
When the washer fluid reservoir is empty,
the washer pump cannot work as intended.
There is a risk of damage to property. Do
not use the washer system when the washer
fluid reservoir is empty.
Cleaning the windshield
To clean the windshield, pull the wiper lever
back.
The washer fluid is sprayed on the windshield,
and the wipers are turned on briefly.
Windshield washer nozzles
The windshield washer nozzles are automati-
cally heated while standby state is switched
on.
Seite 159
Light and view
CONTROLS
159
Online Edition for Part no. 01405A8A536 - VI/23