If the system is manually switched on when
the reverse gear is engaged, the rearview
camera image is displayed.
Depending on the national-market version, the
system cannot be turned off manually when
the reverse gear is engaged.
Acoustic warning
General information
An intermittent tone is given as acoustic warn-
ing for Park Distance Control to signal an ap-
proaching object. E.g., when an object is de-
tected at the rear left of the vehicle, a sound is
heard from the rear left speaker.
The shorter the distance to the object, the
shorter the intervals of the intermittent tones.
An acoustic warning sounds in case of an im-
pending collision at a distance to the object of
approx. 27 in/70 cm.
For objects behind the vehicle, the acoustic
warning is issued as early as a distance to the
object of approx. 5 ft/1.50 m.
When the distance to a detected object is less
than approx. 8 in/20 cm, a continuous tone is
sounded.
When there are objects in front of and behind
the vehicle at the same time, at a distance
smaller than approx. 8 in/20 cm, an alternating
continuous tone will sound between the front
and rear speakers.
The intermittent tones and the continuous tone
are turned off when selector lever position P is
engaged.
Depending on national-market version, the in-
termittent tones are switched off after a short
time when the vehicle is stationary.
If an object approaches when the vehicle is
stationary, the acoustic signal is reactivated.
Adjusting the volume
1.
To adjust the volume of the acoustic warn-
ing, go through the menu as follows via
iDrive: Apps menu / "Vehicle" / "Driving
settings" / "Driver Assistance" / "Parking" /
"PDC signal volume".
2. Set the desired value.
Turning off the acoustic warning
Depending on the national-market version, the
acoustic warning can be switched off after the
start of the parking manoeuver.
Press the acoustic warning icon in the sta-
tus field at the top of the control display.
No audible warning is emitted during active
parking.
When the Park Distance Control is switched
on again, the acoustic warning is automatically
switched on again.
Visual warning
General information
The approach to an object is displayed on the
control display and instrument cluster as soon
as Park Distance Control is activated.
Objects that are farther away are already dis-
played before a signal sounds.
Depending on the view, pathway lines, turning
circle lines and obstacle markings are shown
for a better estimation of the space required.
Depending on the equipment, the detection
range of the sensors is represented by shaded
annular surfaces. Green, yellow, and red mark-
ings indicate when obstacles are detected in
the detection zone.
If your vehicle is equipped with the Cross Traf-
fic Warning, a warning is also shown on the
display for vehicles approaching from the side
at the rear and front.
To protect the sides of the vehicle, obstacle
markings are displayed on the sides of the ve-
hicle.
Seite 247
Parking
CONTROLS
247
Online Edition for Part no. 01405A8A536 - VI/23
To Next Page
Loading...
