BMW X1 - Page 325

Minimum tire pressure not reached
Do not continue driving unless a minimum tire
pressure of 2.5 bar/36 psi is reached. Contact
an authorized service center or another quali-
fied service center or repair shop.
Minimum tire pressure reached
When the tire pressure is at least
2.5 bar/36 psi, proceed as follows:
1. Pull the connector out of the socket in the
vehicle interior.
2. Disconnect the hose from the sealant bottle
and from the valve on the wheel.
3. Screw the valve cap onto the valve.
4. Stow the tire repair set in the cargo area.
5. Immediately drive 5 miles/10 km to ensure
that the tire sealant is evenly distributed in
the tire.
Do not exceed the speed limit of
50 mph/80 km/h.
If possible, do not drive at speeds less than
12 mph/20 km/h.
Tire sealant may spray from the damaged
area when you rotate the wheel initially.
Adjusting the tire pressure
To adjust the tire pressure after using the tire
repair set, proceed as follows:
1.
Stop at a suitable location.
2. Connect the hose directly to the compres-
sor and turn clockwise by 90° until it audi-
bly engages.
3. Unscrew the valve cap on the wheel and
screw the connecting piece of the hose
onto the valve.
4. Insert the connector into the socket in the
vehicle interior.
5. Read the tire pressure on the tire pressure
display of the compressor.
Do not continue driving unless a minimum
tire pressure of 1.3 bar/19 psi is displayed.
Contact an authorized service center or an-
other qualified service center or repair shop.
6. Correct the tire pressure to 2.5 bar/36 psi.
▷ To increase the tire pressure when
standby or drive-ready state is on: Turn
on the compressor and let it run for
max. 10 minutes.
▷ To decrease the tire pressure: Press the
pressure reducing valve button on the
compressor.
Remove and stow the tire repair set
To remove and stow the tire repair kit, proceed
as follows:
1.
Switch off the compressor.
2. Pull the connector out of the socket in the
vehicle interior.
3. Disconnect the hose from the compressor
and from the valve on the wheel.
4. Screw the valve cap onto the valve.
5. Stow the tire repair set in the cargo area.
Seite 325
Wheels and tires
MOBILITY
325
Online Edition for Part no. 01405A8A536 - VI/23