BMW X1 - Page 90

The window closes while the switch is be-
ing held.
▷ On the door, pull the power window
switch past the resistance point.
The window closes automatically.
Pulling again stops the motion.
Jam protection system
Principle
The jam protection prevents objects or body
parts becoming jammed between the door
frame and window while a window is being
closed.
General information
If resistance or blockage is detected while a
window is being closed, the closing will be in-
terrupted.
Safety information
Warning
Accessories on the windows such as anten-
nas can impact jam protection. There is a
risk of injury. Do not install accessories in the
area of movement of the windows.
Closing without the jam protection
system
In case of danger from the outside or if icing
might prevent normal closing, proceed as fol-
lows:
1.
On the door, pull the power window
switch past the resistance point and hold it.
The window closes with limited jam protec-
tion. If the closing force exceeds a certain
threshold, closing is stopped.
2. On the door, pull the power win-
dow switch past the resistance point again
within approx. 4 seconds and hold it there.
The window closes without jam protection.
Opening windows automatically
If a window is opened frequently at the same
place, the opening of the window can be auto-
mated. This is useful if you frequently use the
same parking garage, for example.
Additional information:
Settings, refer to page 85.
Safety switch
Principle
The safety switch can be used to prevent chil-
dren, for instance, from opening and closing
the rear windows using the switches in the
rear.
If an accident of a certain severity occurs, the
safety function is switched off automatically.
Overview
The safety switch is located on the
driver's door.
Seite 90
CONTROLS
Opening and closing
90
Online Edition for Part no. 01405A8A536 - VI/23