EasyManua.ls Logo

BMW X2 2025 - Engine Temperature; Standby State and Driveready State

BMW X2 2025
400 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Tachometer
General information
Always avoid engine speeds in the red warning
field. In this range, the fuel supply is reduced to
protect the engine.
Activating/deactivating the
tachometer
The tachometer is displayed depending on the
selected drive mode or the individually config-
ured layout.
The tachometer display changes depending
on the selected driving mode.
Reduced rotational speed range
The reduced rotational speed range may be
due to certain factors, e.g., a cold drive sys-
tem. The tachometer display is automatically
adjusted depending on the available rotational
speed range.
Standby state and drive-
ready state
If OFF is displayed in the instru-
ment cluster, drive-ready state
is switched off and standby
state is switched on.
If READY is displayed in the in-
strument cluster, the Auto Start/
Stop function is ready to start
the engine automatically.
Additional information:
Operating state of the vehicle, refer to
page 39.
Auto Start/Stop function, refer to page 117.
Engine temperature
The engine temperature is displayed in the in-
strument cluster.
If the engine is cold, the nee-
dle is in the blue temperature
range, close to the limit po-
sition of the temperature dis-
play. WARM-UP is also dis-
played.
Drive at moderate RPM and
vehicle speeds.
At normal operating temperature, the nee-
dle is in the middle or in the left half of the
temperature display.
If the engine is hot, the needle is in the
red temperature range. In addition, a Check
Control message is displayed.
Additional information:
Coolant level, refer to page 350.
Display
The engine temperature is displayed in the in-
strument cluster.
If the engine is cold, the nee-
dle is in the blue temperature
range, close to the left-hand
limit position of the temper-
ature display. WARM-UP is
also displayed.
Drive at moderate RPM and
vehicle speeds.
At normal operating temperature, the nee-
dle is in the middle or in the left half of the
temperature display.
If the engine is hot, the needle is in the
red temperature range. In addition, a Check
Control message is displayed.
Additional information:
Coolant level, refer to page 350.
Seite 143
Displays
CONTROLS
143
Online Edition for Part no. 01405B46537 - VI/24

Table of Contents

Related product manuals