What to do if BNF Toy has incorrect response to the AS3X Control Direction Test?
If your BNF Toy is showing an incorrect response to the AS3X Control Direction Test, do not fly it. This issue is likely due to incorrect direction settings in the receiver, which could lead to a crash. You must correct the direction settings; consult the receiver manual for instructions, and then you can fly.
How to fix oscillation in BNF Carbon-Z Cub?
Oscillation in your BNF Toy can occur for several reasons. You might be flying over the recommended airspeed, so reduce your speed. Other potential causes include a damaged or imbalanced propeller or spinner, in which case you should replace or balance them, respectively. Variations in flight conditions also play a role; adjust the gain accordingly, considering wind, updrafts, and local conditions such as elevation, humidity, and temperature. Motor vibration, a loose receiver, or loose aircraft controls can also lead to oscillation; replace parts or tighten fasteners as needed, and align/secure the receiver in the fuselage or tighten the aircraft controls. Worn parts or irregular servo rotation may also cause oscillation; adjust the gain or replace worn parts, especially the propeller, piv...
Procedure for installing the bind plug in the receiver.
Guidelines for choosing the appropriate Li-Po battery for the aircraft.
Explanation of the ESC's Low Voltage Cutoff feature to protect Li-Po batteries.
Procedure for mechanically centering control surfaces and adjusting linkages.
Checklist for setting up computerised transmitters before binding the aircraft.
Importance of performing a radio system range check before flight.
Explanation of oscillation and how to address it.
Instructions for performing a successful takeoff with the aircraft.
Steps for installing the optional tow release servo and mechanism.
To Next Page
General
